| STANDARD FEATURES: |
| Voltage: 120 or 220V AC, Solar panel
Frequency: 50 or 60Hz
Amp Draw: 2 Amperes Nominal
Backup Power: Requires (2) 7 Amp Hour 12 Volt DC (Yuasa NP7-12 or Equivalent)
Chassis: 1/4" Heavy Duty Rust Proof T-6 Aluminum Construction
Cover: Removable Heavy Duty Molded U.V. Stable Polyethylene (White Standard, Colors Optional) Meets UL-746C, 94-5VO
Finish: Polyester Polyurethane Baked On Power Coat (White Standard)
Weight: 105 lb (Without Arm)
Barrier Arm (not included, sold separately) Operation: Breakaway
Design - Reusable Arm Attaches With Nylon Nuts
Lengths: 9' x 4" O.D. Soft Padded Arm - Yellow Padded Sleeve (Uses 2" O.D. Tube) (Require Adaptor Collars)
Material: 2" O.D. Extruded Aluminum with 4" O.D. Soft Yellow Pad.
Motor: High Torque 1/2 HP 24 VDC Permanent Magnet (TENV) - With Permanently Sealed Bearings
Transmission: 60:1 Heavy Duty Gear Reducer
Arm Travel: 89 Degrees Approximately
Raise/Lower: 0.9 to 1 Second
Mechanism: Direct Drive - No Crank Arms Or Rubber Bumpers
Electronic Controller Technology: Micro Controller Based (RISC)
Surge Protection: All Inputs Protected By Ultra Fast Transorb Surge Arrestors
Isolated Inputs: Opto Isolated - Open, Close, Free Exit, Safety, Shadow, Aux Open Has Memory/Non-Memory
Outputs: K1 Relay (Option), 24 VDC Regulated Accessory Power (500MA)
Terminals: One 12 Pin Removable, Three 4 Pin Removable
Timers: Select On/Off With 1 - 33 Seconds Via DIP Switch Selection
Position Sensing: Magnetic Hall Effect Sensors - No Mechanical Roller Switches
Motor Drive Output: State Of The Art Mosfet Motor Drive Technology
Compatibility(Accessories): All AVI, Laser Barcode Scanners, Radio Receivers, Card Readers, Ticket Machines, Loop Detectors, Push Buttons, Token Machines. Note: Up To .5 Amp (500MA) 24 VDC Backed Up Accessory Power Available to Power Above Devices.
Dip Selections (Switches): Aux Input Memory/Non Memory, Timer On/Off, Auto Raise Arm If Power Fails With 15 Sec Delay/Fail Secure - Right Hand Operation/Left Hand Operation, Relay Pulse On OLS/Relay On Except When On CLS, tail gate and tamper.
Options Relay: K1 Relay With Programmable Operation (Tailgate and tampers alarm latch, INTERLOCK, arm position, trap pulse and isolation)
Heater: 150 Watt Heater With Automatic Thermostat (For Use In Areas Where Temperatures Fall Below 15° F)
Slip Clutch : Allows arm to be forced up without causing damage - Arm lowers and self Aligns after car passes or set to close by timer. Arm will automatically re-level itself.
Cabinet: Full length rust proof aluminum tower
|
|
